11.12 Deactivating block mode
Required master media:
l Block-Master
The Program-Master must first be authorised for the locking device on which it is to be
used, see "Authorising additional master media" on page111
Procedure:
1. Hold the Block-Master before the reading field of the locking device.
After ca. 2 second, the following signal appears:
2x short green
2. Remove the Block-Master from the reading field of the locking device.
The blocking mode is now deactivated. An access with an authorised locking media is now possible
again.
Troubleshooting:
Signalling Reason Solution
A higher-priority opening mode is cur-
rently active (see "Hierarchy of the open-
ing modes" on page84).
Deactivate the
opening mode with higher priority.
The Block-Master is not authorised. Authorise the
Block-Master
Long shield ILS Page125 of 141
11.12 Deactivating block mode
Overview: Master media usage
Help & troubleshooting
Technical data
Maintenance & disposal Operation Administration Assembly Basics
To Next Page
Loading...
