CEStronics CES OMEGA FLEX - Error Signalling

10.3 Error signalling
Signalling Reason Solution
After reading a master media:
Master media error:
a) The master media is not authorised. a) Authorise the master media.
b) For master media, which control the
opening modes: An opening mode with
higher priority is active (see "Hierarchy of
the opening modes" on page84).
b) Deactivate the opening mode with
the higher priority.
c) The master media cannot be read
because of the locking device variant (e.g.
Program-Master for V-NET devices).
c) Check whether the master media
can be used with the concerned
device types.
After reading a master media or locking media:
1 The media is not authorised for this
device.
or
1. Authorise the media for this device
or
2. The media could not be read completely
because:
a) it was not held long enough in the
reading field .
2a) Keep the media for a longer
period in the reading field of the
locking device.
b) The master media or the V-NET locking
media has wrong system Identification
code.
2b) Use a master media or V-NET
locking media with the right system
identification code.
c) a LINE locking media was held in the
reading field of a V-NET device.
2c)LINE locking media could not be
read by V-NET devices.
Additionally after reading the authorised or unauthorised locking media:
or
or
The battery alarm indicates that the
batteries are going to be empty soon (see
"Maintenance" on page91).
Replace the batteries(see
"Maintenance" on page91).
Page 106 of 141 Long shield ILS
10.3 Error signalling
Overview: Master media usage
Help & troubleshooting
Technical data Maintenance & disposal Operation Administration Assembly Basics