11.5 Authorising locking media
Required media:
l Program-Master
l Any locking media that needs to be authorised
The Program-Master must first be authorised for the locking device on which it is to be
used, see "Authorising additional master media" on page111
Procedure:
1. Hold the Program-Master for ca 1 second in the reading field of the locking device to start
the “authorise mode.
The following signal appears:
1x short green
2. Now you can authorise any number of locking media one after the other by holding each
locking media for ca 1 second in the reading field of the locking device.
The following signal appears for each locking media:
1x short green
Page 116 of 141 Long shield ILS
11.5 Authorising locking media
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration Assembly Basics
To Next Page
Loading...
