4.2.2 Check the coupling module
The lever handle position of the handle set is pre-set at the factory.
Left lever handle position Right lever handle position
To ensure that the handle set functions properly, the position of the coupling follower must
correspond with that of the lever handle:
Left lever handle position:"L" is on top. Right lever handle position:"R" is on top.
If the coupling socket does not match the alignment of the fitting you must turn the
coupling socket back into the correct position. If the coupling socket is twisted a fitting
cannot couple or engage in the socket! If the coupling follower does not correspond with
the lever handle position of the handle set, you need to turn the coupling follower back to
the correct position.
Long shield ILS Page 17 of 141
4.2 Preparations for assembly
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration
Assembly
Basics
To Next Page
Loading...
