Procedure for transmitting programming jobs via an RF-Stick:
1. Proceed with your PC and the RF-Stick connected to it to the locking device into which the
programming jobs are to be transmitted.
If you want to transmit the programming jobs into multiple locking devices, you can freely
choose the sequence in which you look for the locking devices.
2. Hold the RF-Stick-Master briefly in the reading field of the locking device.
The following signal appears:
1x short green
3. The locking device searches now for an RF-Stick nearby.
The distance between the locking device and the RF-Stick may not exceed ten meters.at
the maximum.
As soon as the RF-Stick has been detected, the transmission begins. During transmission, the
locking device flashes green.
During transmission the following happens:
Page 134 of 141 Long shield ILS
11.18 Transmitting programming jobs using RF-Stick to a locking device
Overview: Master media usage
Help & troubleshooting Technical data Maintenance & disposal Operation Administration Assembly Basics
To Next Page
Loading...
