CFMoto Uforce 500 - Speed Limit Override Switch - ⑦; Hazard Switch - ⑧

CONTROLS AND FEATURES
60
Speed Limit Override Switch - ⑦
The engine is normally speed limited when operating in
4WD-LOCK. If conditions require more engine power:
 Release the throttle and press the button to
override the speed limiting function. The override
indicator light will come on.
 Reapply the throttle while this button is pressed.
 Releasing the button restores the speed limiting
function.
NOTE: Speed limit override is not available in 2WD.
WARNING
Pressing the override button while the throttle is open in speed limiting mode may cause sudden
acceleration, resulting in a loss of control, severe injury, or death. Always release the throttle before
pressing the override button.
Hazard Switch - ⑧
(If equipped - available only in select countries)
When using the hazard switch function, the front and rear turn signal lights will flash. Also, the hazard
switch indicator light in the dashboard will light up.
⑧
⑦
⑩
⑨
⑪