CFMoto Uforce 500 - Multi-function Lever - ⑨; Main Light Switch; Low Beam; High Beam

CONTROLS AND FEATURES
61
Multi-function Lever - ⑨
The multi-function lever is located on the left side of the
steering column.
Main Light Switch
The main light switch consists of 4 positions. Turn the
barrel of the lever to select the following functions:
OFF
Head lights and tail lights are ‘OFF’ when the
switch is turned to this position.
Position / tail lights ‘ON’ and dead lights ‘OFF’
when the switch is turned to this position
.
Low Beam / High Beam
Low Beam is selected when the switch is turned to
this position.
High Beam is selected when the switch is turned to
this position.
NOTE:
Ignition key must be turned to ‘ON’ before operating head lights.
CAUTION
Do not use the headlights with the engine turned off for more than 15 minutes. The battery may
discharge to a point that the starter motor will not operate properly. If this should happen, remove
the battery and recharge it.