EasyManua.ls Logo

CFMoto Uforce 500 - Crossing Paved Roads; Riding on Paved Surfaces

Default Icon
182 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATING YOUR VEHICLE
95
WARNING
When driving downhill in reverse, gravity can increase the vehicle speed above the set limited
reverse speed. Failure to use caution when operating in reverse can result in serious injury or death.
NOTE:
This vehicle is equipped with a reverse speed limiter function. In reverse operation, the engine RPM
is limited, thus limiting the vehicle reverse speed. Do not operate at wide open throttle. Open the
throttle just enough to maintain a desired speed.
Crossing Paved Roads
If you have to cross a paved road, ensure to have complete visibility on both sides for incoming
traffic and decide on exit point on other side of road. Drive in a straight line toward that point. Do not
make sharp direction changes or abrupt accelerations as it may result in a rollover situation. Do not
travel on sidewalks or bicycle trails, as they are designated specifically for those uses.
Riding on Paved Surfaces
Avoid paved surfaces. This vehicle is not designed to operate on paved surfaces and is more likely
to roll over. If you must drive on pavement, turn gradually, go slowly, and avoid abrupt acceleration
and braking.

Table of Contents

Related product manuals