OPERATING YOUR VEHICLE
79
Operating Your Vehicle
Break-In Period
The break-in period for a new engine is very important. Careful treatment of a new engine at the
beginning of ownership will result in more efficient performance and longer life. Perform the following
procedures carefully:
1. Select an open area that allows room to familiarize yourself with vehicle operation and
handling.
2. Place the vehicle on a level surface.
3. Fill the fuel tank with gasoline.
4. Check the engine oil level. Add the recommended oil if necessary to maintain the oil level
between the minimum and maximum indicators on the dipstick.
5. Position yourself in the operating position on the vehicle, fasten the seatbelt and safety nets,
and start the engine. Allow the engine to idle for a short period before operating.
6. Press the foot brake, select the desired gear, and then release the foot brake.
7. Apply throttle. Drive slowly at first, varying throttle positions to ½ open for 10 hours, then
vary to ¾ open for an another 10 hours. Do not operate at sustained idle or sustained wide
open throttle.
8. Do not pull or carry any heavy loads during the break-in period.
9. Periodically check coolant level, controls, etc. along with the items outlined in the periodic
maintenance chart.
10. At the end of the break-in period, change the oil and filter (20hrs or 466 miles / 750km).
To Next Page
Loading...