CONTROLS AND FEATURES
64
On-Command 2WD / 4WD / 4WD-LOCK Switch Operation
To change from 2WD to 4WD: Stop the vehicle. Verify the mode lever is moved to the left, and
then press the switch to “4WD”. The 4WD indicator “ “will display in the dashboard.
To change from 4WD to 2WD: Stop the vehicle. Verify the mode lever is moved to the left, and
then depress the switch to “2WD”. The 2WD indicator “ ” will display in the dashboard.
To change to 4WD-LOCK: Stop the vehicle. To lock the front differential while in 4WD mode, verify
the mode lever is moved to the right, and then depress the switch to “LOCK”. The 4WD-LOCK
indicator “ ” will display in the dashboard.
NOTE: 4WD-LOCK OPERATION:
Steering will require greater effort in 4WD-LOCK mode. This is normal.
When the switch is set to “LOCK”, the front diff-lock indicator light will flash until the front diff
is locked.
If the indicator light is flashing, turning the steering left and right will help the front gear
locking mechanism to engage.
Riding before the front differential lock is properly engaged (e.g., the indicator light is
flashing) will cause the engine speed to be limited until engagement is complete.
When the vehicle is in 4WD-LOCK, the maximum traveling speed is limited to 22 mph (35
km/h).
If conditions require full engine power to be available, press the override switch on the
dashboard to disable the 4WD-LOCK speed limiter.
To Next Page
Loading...