CH L1 - Factory Setting

4.3.1.4 FACTORY SETTING
The L1 SETUP >> FACTORY SETTING menu allows to get information about the
current L1 firmware version, to update the L1 firmware and to reset the unit to
its default configuration (or subset of setting).
Accessible Parameters are:
- FIRMWARE VERSION:
- UPDATE FIRMWARE:
- RESET ALL SETTING:
- SERIAL NUMBER:
- SHORTCUTS:
- INPUT ENABLED:
- INPUT GAIN:
- INPUT NAMES:
- REMOTE CONTROL:
- CALIBRATE:
- NETWORK KNOWLEDGE:
Current firmware version (read only)
Allows to update the unit's firmware
Returns the unit to factory settings
Display this L1's serial number
Redefines all Shortcuts to factory default
Allows to enable all inputs at once
Reset all input gain to 0 dB
Set default names to all inputs
Select to which set of RC5 commands the L1 responds
Run self-calibration process
Clears all network knowledge in the device
The following table details the Parameters of the FACTORY SETTING menu:
PARAMETER RELATED ACTION/VALUE REQUIRED OPTIONS REMARKS
FIRMWARE VERSION Firmware version None Firmware version indicates the version of the
current firmware. Format is x.y. This parameter is
read only.
UPDATE FIRMWARE Update None Selecting 'Update' launches the L1 firmware update
process. A USB flash disc drive with a valid set of
firmware must be inserted in the A-shaped USB port
RESET ALL SETTING Reset None Selecting 'Reset' returns the L1 to its factory
settings. Factory settings are detailed in the
Specifications section.
SERIAL NUMBER Serial number None Serial number indicates the serial number of the L1.
Format is yymm06nn. This parameter is read only.
SHORTCUTS Default mapping None Selecting 'Default Mapping' returns the L1's
Shortcuts to their factory settings. Factory settings
are detailed in the Specifications section.
INPUT ENABLE Enable all None Selecting 'Enable all' will enable all available
L1inputs.
INPUT GAIN Set default gain None Set back the gain/attenuation of all inputs to 0dB.
INPUT NAMES Default names None Set back all input names to their default value
REMOTE CONTROL None
RC5 Pre1
None Selects to which set of RC5 commands the L1 will
respond to. Pre1 is the standard RC5 Preamplifier
Rev 1.0 L1 User Manual 37