RC5 Pre2 set, Pre2 is an alternate RC5 Preamplifier set (Pre1
corresponds to the set of commands the L1 remote
control sends by default and Pre2 to the set of
commands the C1 remote control sends by default).
When 'None' is selected, the L1 cannot be
controlled by a remote control anymore.
CALIBRATE Start calibration L1 must be warmed-up Launch automated self calibration to measure and
compensate DC at all stages of the L1 signal path.
This calibration process is conducted in CH Precision
factory prior to packing any L1.
In order to avoid overriding these factory measured
valued with inaccurate ones, the L1 must be
powered for at least 1 hour before this function is
available, to ensure the L1 is warmed up and all
internal stages have stabilized.
NETWORK
KNOWLEDGE
Reset None Clears the L1's memory of other CH Precision
devices it has discovered through the TCP/UDP
proprietary protocol.
Details of FACTORY SETTING menu Parameters
4.3.1.5 INSTALLED OPTIONS
The L1 SETUP >> INSTALLED OPTIONS menu provides read-only information
about installed boards. Details are:
- TOP SLOT:
- BOTTOM SLOT:
Board installed in top slot (board type and channel)
Board installed in bottom slot (board type and channel)
The following table details the Parameters of the INSTALLED BOARD menu:
PARAMETER PARAMETER VALUES REMARKS
TOP SLOT Left, Right, Left extended, Right
extended, Left surround, Right
surround, Center or Sub preamp
Parameters are Read Only
BOTTOM SLOT
Details of INSTALLED OPTIONS menu Parameters
38 L1 User Manual Rev 1.0
To Next Page
Loading...
