37
Motion Detecting Control Panel Setup
TIMER-TO-CLOSE (TTC)
NOTE: DO NOT enable TTC if operating a one-
piece door. TTC is to be used ONLY with
sectional doors.
The TTC can be turned on or offand the time
interval can be adjusted to 1, 5,and 10 minute
intervals. Once the TTC hasbeen setand the
door is open, the selected close interval will blink
and begin to count down to close the door.
Activate: Press and hold the ON button until
one of the TTC LEDs lightup.
Then press the ON button again to cycle through
the time interval options(the corresponding TTC
LED will lightfor each time interval). The garage
door opener light bulbs will blinkas
confirmation.
Deactivate:Pressand hold the OFF button until
all TTC LEDs turn offand a beep is heard from
the motor unit.
Temporarily hold door open (suspend TTC):
Press and release the HOLD OPEN button.
Press the HOLD OPEN button again to resume
normal TTC operation.
ON (TTC)
OFF (TTC)
HOLD OPEN
(TTC)
1 Minute,
5 Minute
and 10
Minute
TTC LED
LOCK
Activate:
Press and hold the
LOCK button for 2
seconds. The
command LED will
flash aslong as the
lockfeature is
activated and your
handheld remote
control will not operate
your door at this time.
Deactivate:
Press and hold the
LOCK button again for
2 seconds.The
command LED will
stop flashing and
normal operation will
resume.
LIGHT
To change the amount of time the garage dooropener lights will stay on:
Press and hold the LOCK button until the garage door opener lights flash.* The time interval is indicated
by the number of flashes.
NUMBER OF TIMES GARAGE DOOR OPENER
LIGHTS FLASH
TIME THE GARAGE DOOR OPENER LIGHT
STAYS ON
1 1 1/2 Minutes
2 2 1/2 Minutes
3 3 1/2 Minutes
4 4 1/2 Minutes
To cycle through the time intervals repeatthe step above.
LIGHT FEATURE
Deactivate:
Press and hold the LIGHT button until the garage door opener lights turn on,then offagain.*
Activate:
Startwith the garage door opener lightson. Press and hold the LIGHT button until the garage door
opener lightsturn off, then on again.*
NOTE: If the command LEDis continuously blinking, the LOCKfeature needs to be deactivated.
LOCK Button
LIGHT Button
Command LED
* Approximately 10 seconds
MOTIONSENSOR
Activate/Deactivate:
Slide the motion
sensor switch ON or
OFF.
Motion Sensor
Switch
Motion
Sensor
Door Control
To Next Page
Loading...
Need help?
General
