38
Smart Control Panel Setup
The features on the door control can be programmed through a seriesofmenus on the screen and the navigation buttons. Refer to the descriptions below.
SCREEN
The main screen displaysthe time, temperature, and current
battery charge (if applicable).
FEATURES
Press the navigation button below "MENU" to view the Features menu.
CLOCK SETUP: Setthe time, choose 12 or 24 hour clock and
show/hide clock.
TTC SETTINGS (for sectional doors ONLY):
Set the Timer-to-Close feature off/on and setthe time interval before
door closes.NOTE: DO NOT enable TTC if operating a one-piece
door. TTC is to be used ONLY with sectional doors.
LOCK: Enable/disable lock.
PROGRAM: Add remote controls, MyQ™ devices, an extra remote
button to control your garage door opener lights,or a keyless entry.
SETTINGS
Press the navigation button below the down arrow till you see
TEMPERATURE to view the Settings menu.
TEMPERATURE: Displaythe temperature in Fahrenheitor
Celsiusand show/hide the temperature.
LANGUAGE: Select a language.(English,French or
Spanish).
LIGHT SETTINGS: Set duration for garage door opener light
to stay on after operation,selectable range of 1-1/2 to 4-1/2
minutes. Turn the Motion sensor off/on,and turn the entry light
feature off/on.
CONTRAST: Adjust the contrast ofthe screen.
To program a remote control or keyless entry to the garage door opener using the door control see page 39.
Door Control
To Next Page
Loading...
Need help?
General
