http://www.charmhigh.com
Charmhigh-V1.0-2016 | Hunan Charmhigh mechanical and electrical co., LTD
All Rights Reserved
Figure.6- 18
(1) Comp. ID: Showing current component number/total number, click to set current
component number, such as start from the 3
rd
or 5
th
.
(2) PCB ID: Show current PCB number/total PCB number, click to set current PCB
number which mount, set as above.
(3) Comp. cnt.: Show total mounted component count this run time.
(4) Pcb cnt.: Show total mounted PCB count.
(5) Ave. speed: Show average mount speed, unit is chip per hour.
(6) Time cnt.: run time of this time.
(7) Tray start IC: Click to set the start IC’s ID of IC tray; (below ‘Time cnt.’Not viewing
where hasn’t tray information in file).
(8) Up camera: The first button in the left bottom of screen, click to show image of up
camera.
(9) Work light: The second button in the left bottom of screen, click to switch work
light.
(10)PCB calibration: The third button in the left bottom of screen, click to calibrate
PCB directly.
(11)Mount head homing: The fifth button in the left bottom of screen, click to move
mount head to the farthest location to origin.
(12)Vacuum detection: The fourth button in the left bottom of screen, click to open or
close vacuum detection, note, if close vacuum detection here, machine will not
detect lack of material, also will not discard material due to vacuum insufficient.
To Next Page
Loading...
