Chatillon DFS II User Manual

24 DF II Series User Manual
Transmit Using RS232
The DF II Series gauge will communicate to a
serial device using its RS232 output. Connect to
the device using the RS232 cable (p/n SPK-DF-
RS232).
Transmit Using Mitutoyo
The DF II Series gauge will communicate to a
MitutoyodevicewhenconguredwiththeMitutoyo
output. Connect to the device using the Mitutoyo
cable (p/n NC000654).
( p/n SPK-FMG-USB)
DF II Series Gauge
USB Port
( p/n NC000654)
DF II Series Gauge
Mitutoyo Connector
- 10 Pin Male
The gauge can transmit information with or without
units.
If the F1 label indicates “Xmit-O”, the gauge will
transmit data withOut units.
You can select how you want data to be transmitted
at the COMMUNICATION SETUP MENU.
If the F1 label indicates “Xmit-W”, the gauge will
transmit data With units.
Gauge will transmit result WITHOUT units.
Gauge will transmit result WITH units.
Transmit WITH UNITS (Xmit-W)
Transmit WITHOUT UNITS (Xmit-O)
NOTE: The DFE II model does not have Bluetooth
®
capability. It cannot transmit a result wire-
lessly. Bluetooth
®
range is 4 to 10 feet.
Analog Output
The DF II Series gauge supplies a +2Vdc
(+0.015Vdc) analog output. The output is a linear
signal with a 200Hz frequency. The analog output
may be used to drive annunciators, recorders or
other external devices.
Transmit Using Bluetooth
®
The DF II Series gauge will communicate to a se-
rial device using its Bluetooth
®
output. Connect to
the device using the Bluetooth
®
wireless communi-
cation as would be done with any other Bluetooth
®
device.
Transmit Using USB
The DF II Series gauge will communicate to a se
-
rial device using its USB output. Connect to the
device using the USB cable (p/n SPK-FMG-USB).
( p/n SPK-DF-RS232)
DF II Series Gauge
RS232
- O

Chatillon DFS II Specifications

General

Brand	Chatillon
Model	DFS II
Category	Measuring Instruments
Language	English