32 DF II Series User Manual
If the measured result falls below the LOW setpoint,
the gauge will display “L-LO” until the result is
greater than the LOW setpoint value.
If the measured result exceeds the HIGH setpoint,
the gauge will display “L-HI” until the result is less
than the HIGH setpoint value.
USING LOAD LIMITS
The DF II Series force gauge allows you to setup
and apply LOAD LIMITS. You may setup HIGH
and LOW load limits. Load Limits are useful for
protecting your gauge or testing system from dam
-
age or to simply alert you that the gauge or system
has exceeded a setpoint value.
LOAD LIMIT BUZZER
You may setup your DF II Series gauge to provide
an audible alarm whenever a Load Limit has been
reached. When the buzzer is enabled, an icon will
show in the main display.
Low Setpoint
High Setpoint
To Next Page
Loading...
