52 DF II Series User Manual
LOAD AVERAGE SETUP
To setup the Load Average function, from the
Home display depress F3 (More) three times. Use
the navigation key to position the arrow at the
“Load Average” function. Press ENTER.
LOAD AVERAGE - SELECT TYPE
The DFS II load average default type is Load Aver-
age Force-Based. The setup menu will display the
current Preload Value (PreL).
To change the Load Average type to Time-based,
select the F1 (T-ON) key. The gauge will now
display “Time”. A cursor will appear next to the
“Preload” value. Use the F1 key to toggle between
the two available Load Average Types.
SELECTING INCREMENTS
Increments are associated with the numeric values
displayed by the gauge during setup. You select
the increment you want to use to adjust your setup
values. Increments are provided in values
corresponding to the gauge capacity and units of
measure. Increment values available are:
n 0.001
n 0.01
n 0.1
n 1.0
n 10.0
n 100.0
Selecting an increment of 10.0 will adjust the setup
numeric value by “tens”. Selecting the increment
0.1 will adjust the setup numeric value by “tenths”.
You select increments using the RIGHT and LEFT
arrow keys on the navigation pod. Selecting the
RIGHT arrow increases the increment value.
Selecting the LEFT arrow decreases the increment
value.
To Next Page
Loading...
Need help?
General
