Chore-Time Tronics 3 - Feed Winch Clock Setup; Weigh Fill Clock Setup

Chore-Tronics® 3 Breeder Edition Control Control Setup
MT2484A
25
Feed Winch Clock
The Feed Winch clock is used to lower the Male Feeder.
1.On-at: The time of day that an event will start.
2.Off-at: The time of day (hours:minutes:seconds) that an even will run.
3.Run-for: The total time in (hours:minutes:seconds) that the Feeder will run.
4.Events: The desired number of timed events. The maximum number is 24.
5.Use Curve: Select On or Off from dropdown. The Curves are selected from the Run For Curves.
6.Curve: Select the Curve number you want to use from the dropdown.
Note: Feed Winch Clock will lower the Male Feed Line only. Line must be manually raised.
Weigh Fill Clock
The Weigh Fill Clock is used to control the Fill system that supplies feed to a Weigh bin on Load cells.
1.On-at: The time of day that an event will start.
2.Off-at: The time of day (hours:minutes:seconds) that an even will run.
3.Run-for: The total time in (hours:minutes:seconds) that the Feeder will run.
4.Events: The desired number of timed events. The maximum number is 24.
5.Use Preset was setup in the Feeder Fill Clock.
6.Preset amount was setup in the Feeder Fill Clock.
1
2
3
4
5
6
4
5
6
1 2 3