Christ ALPHA 2-4 LDplus - Packaging; Transport Safety Device

Freeze-dryer Alpha 1-4 LDplus
Freeze-dryer Alpha 2-4 LDplus
4 Storage and transport
Version 11/2006, Rev. 2.2 of 17/10/2016 • sb
31 / 102
Translation of the original operating manual
Pos: 85 /200 Chri st/361 GT-BA Labor-Pilot (PR OJEKTE)/Al pha/Alpha 1-4 _2-4 LDplus/040 L agerung und Tr ansport/040-00 40 Verpac kung Alpha 1-4_2- 4 LDplus @ 35\ mod_143037 9588892_68.doc x @ 258671 @ 2 @ 1

4.4 Packaging
The freeze-dryer is packaged in a cardboard box or in a wooden crate,
depending on the scope of supply.
• After opening the packaging, take out the box containing the
accessories.
• Remove the packaging material.
• Lift the freeze-dryer upwards and out of the crate/cardboard box. When
lifting the unit, always reach under the freeze-dryer from the side.
CAUTION
The freeze-dryer Alpha 1-4 LDplus weighs approx. 42 kg!
The freeze-dryer Alpha 2-4 LDplus weighs approx. 55 kg!
• Retain the packaging for any possible future transport of the freeze-
dryer.
Pos: 86 /010 Uni versalmodule/ Leerzeile @ 0\mod_120 2116244500_ 0.docx @ 11 4 @ @ 1
Pos: 87 /200 Chri st/361 GT-BA Labor-Pilot (PR OJEKTE)/Al pha/Alpha 1-4 _2-4 LDplus/040 L agerung und Tr ansport/040-00 50 Transportsic herung Al pha 1-4_2-4 LDpl us @ 35\mod _1430379589 169_68.doc x @ 258686 @ 2 @ 1

4.5 Transport safety device
Prior to start-up, the vacuum sensor must be installed (see chapter 5.4 -
"Vacuum sensor").
NOTE
Prior to any transport, the vacuum sensor must be deinstalled.
Pos: 88 /010 Uni versalmodule/A bschnittswechsel @ 0\mod_ 12021245140 62_0.docx @ 4 18 @ @ 1
Pos: 89 /010 Uni versalmodule/S eitenwechsel @ 0\mod_120 2116244312_ 0.docx @ 105 @ @ 1