Christ ALPHA 2-4 LDplus - Maintenance and Service; Maintenance

Freeze-dryer Alpha 1-4 LDplus
Freeze-dryer Alpha 2-4 LDplus
8 Maintenance and service
Version 11/2006, Rev. 2.2 of 17/10/2016 • sb
59 / 102
Translation of the original operating manual
Pos: 169 /200 Chris t/360 GT-B A Labor-Pilot ( STANDARDMOD ULE)/080 W artung und Insta ndhaltung/080 Wartung un d Instandhaltung== ======= ========== ======== @ 25\ mod_140498409 5704_68.docx @ 184307 @ 1 @ 1

8 Maintenance and service
The freeze-dryer and the accessories are subject to high mechanical
stress. Thorough maintenance performed by the user extends the service
life and prevents premature failure.
CAUTION
If corrosion or other damage occurs due to improper care, the
manufacturer cannot be held liable or subject to any warranty claims.
• Use soap water or other water-soluble, mild cleaning agents for
cleaning the freeze-dryer and the accessories.
• Do not use corrosive and aggressive substances.
• Do not use solvents.
• Do not use agents with abrasive particles.
• Do not expose the freeze-dryer or its accessories to intensive UV
radiation (e.g. sunlight) or thermal stress (e.g. by heat generators).
• Do not turn the unit upside down in order to clean it.
Pos: 170 /010 Uni versalmodule/ Leerzeile @ 0\mod_12 02116244500 _0.docx @ 1 14 @ @ 1
Pos: 171 /010 Uni versalmodule/ Leerzeile @ 0\mod_12 02116244500 _0.docx @ 1 14 @ @ 1
Pos: 172 /200 Chris t/360 GT-B A Labor-Pilot ( STANDARDMOD ULE)/080 W artung und Insta ndhaltung/080-0 010 Wartungs arbeiten------------------------------------------------------------------------- @ 25\mod_140498 4096680_68.doc x @ 184321 @ 2 @ 1

8.1 Maintenance
Pos: 173 /200 Chris t/360 GT-B A Labor-Pilot ( STANDARDMOD ULE)/080 W artung und Insta ndhaltung/080-0 010-0010 Allg emeines L abor @ 25\mod_ 14049840978 32_68.docx @ 1 84335 @ 3 @ 1

8.1.1 General
The general state of the freeze-dryer must be checked at regular intervals.
Any defects must be eliminated immediately! The following points are of
particular importance:
• dirt
• leaks
• corrosion
• bent system components
• loose screw and flange connections
• higher noise levels
• loose cables
• open cable ducts
• missing or illegible safety notes and hazard warnings
• missing or illegible inscriptions on components, pipes (direction of flow)
and cables
• etc.