HIPOT Tester 19051/19052/19053/19054 Quick Start Guide
1
1. Introduction
1.1 An Overview of Product
Automatic withstand / insulation / grounding testers of the instrument are
designed for automatic withstand, insulation resistance, grounding
resistance and short/open circuit detection of electromechanical and
electronic equipments.
The testing aspect of withstand voltage, the output power of the tester is AC:
150VA(5kV, 30mA), DC: 60VA(6kV, 10mA). Therefore, it is for withstand
test of electronic and electromechanical and component.
The testing aspect of insulation resistance, the measurement range of the
tester is 0.1MΩ ∼ 50GΩ and test voltage range is 50V ∼ 1000V can be set
arbitrary.
In the testing aspect of short/open circuit detection, please test if test
capacitance is short or open before testing high voltage. Please make
sure the DUT good contact then processes high voltage test.
All of setting status, time, current, voltage, resistance value, memory
number etc are listed on the display, it is unnecessary to remember any
parameter status which be set.
The tester is equipped with Good and No Good judgment machinery and
signal output of testing result and remote control. It is also for GPIB
interface and RS232 interface of automatic test system. The above
equipments makes high efficient and accurate test.
To Next Page
Loading...
