Chroma 19051 - Store Memory

HIPOT Tester 19051/19052/19053/19054 Quick Start Guide
23
3. Press Function Key SELECT and then show confirm window.
4. Press Function Key YES to confirm or press Function Key NO to
cancel.
3.5.5 Store Memory
If you want to save test parameter data which be set in the memory.
Please follows the below procedures to process.
1. When status bar shows [SELECT FUNC.], press Function Key STORE.
2. Selecting the memory want to store by using Function Key UP, DOWN.
Press Function Key SELECT, the cursor become underscore blinking
cursor.
3. At this time, input the memory name by using Function Key UP,
DOWN.
4. By using Function Key ENTER to move the underscore blinking cursor
to next character.
5. If press Function Key ENTER twice then will show a read confirmation
window.
6. Press Function Key YES to confirm or press Function Key NO to
cancel.
Note
If there is covered data in the memory name, please be careful
to confirm before storing