Overview
1-3
Figure 1-1 AC INPUT Power Spec. Label
1.5 Fuse
The meter has one fuse installed on the rear panel. Please be aware of the following when
replacing it:
(1) Be sure to turn off the power and unplug the power cord before changing the fuse.
(2) Since visual check cannot make sure the fuse to be used is appropriate, it is necessary
to test its resistance to see if it is below 2Ω which is normal for usage.
Table 1-1 Specification of Fuse
Specification
Power Fuse
Slow blow 2.5A / 250V
WARNING
To prevent fire from occurring it is required to use the fuse of same type
and same specification for replacement.
AC INPUT Power
Specification
To Next Page
Loading...
