EasyManua.ls Logo

CHTC HT45 - Windshield Wiper and Steering Wheel Adjustments

Default Icon
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
25
Windshield Wiper Controls
Windshield Wipers
CAUTION
Do not operate wiper in dry conditions. Activate the washers for
proper lubrication before wiper operation.
The rotating switch on the right lever controls the windshield wipers,
including the intermittent wiper control. The rotating switch has four
positions:
OFF-Wiper is off.
INT-Wiper on intermittent setting.
LO-Wiper on low speed setting.
HI-Wiper on high speed setting.
Turning this switch to the first position turns on the wiper intermittently,
frequency of the wiper blades depends upon the setting of the delay
switch. In intermittent, the wipers operate every few seconds.
Turning this switch to the second position turns the wiper on a low
speed. In low speed, wipers run continuously.
Turning this switch to the third position turns the wiper on a high speed.
In high speed, wipers run continuously.
Windshield Washer
The right lever controls the windshield washer. To clean the windshield,
push the button on the end of the lever to turn on the windshield
washer. The washer will spray until you release the button.
Steering Wheel Height Control
WARNING
Adjusting the steering wheel position while driving may cause you
to lose control of the motor coach, and to seriously injure you and
your passengers. Adjust the steering wheel only when the motor
coach is stopped.
Turn lock-handle located on left side of steering column
counterclockwise to adjust steering wheel height. Tighten by turning
lock-handle clockwise.
WARNING
Make sure you have securely locked the steering wheel in place by
trying to move it.

Table of Contents