LAVATORY
General Information
For safety and convenience, the toilet module has been installed with
safety handles inside and out of the module.
The dashboard contains an indicator for the following:
•
When The module is vacant or occupied.
•
For The status of the wastewater holding tank.
•
To alert the driver that the alarm button in the toilet module has
been activated.
•
Then The wastewater holding tank is full.
NOTE: If wastewater holding tank indicator is on, stop using toilet
immediately and ensure door is properly locked.
The toilet module door has a seal strip which prevents odors from
entering the motor coach. The toilet module is equipped with dual fans.
Low fan speed will vent constantly when the module is vacant. The fan
will change to high speed when the module is occupied. The outer fan
works to keep fresh air moving automatically.
The power to the toilet is controlled by the driver at the dashboard. If the
toilet is not functioning properly, the driver can turn off power and
temporarily put the toilet out of order.
NOTE: If the toilet is to be out of service for an extended time, turn off
the main power to the toilet.
Pre-Trip Procedures
Ensure that the freshwater tank is full.
Fresh water tank for lavatory is located at the rear driver side
compartment on top of trailing axle. Fill freshwater tank by attaching
water hose and opening valve. Fill full and close fill valve. Fold wheel
skirt down and securely latch.
Check that wastewater tank is completely drained and drain valve
closed prior to trip. Make certain trash bin is empty prior to trip.
Check that toilet paper, paper towels, and other supplies are fully
stocked prior to trip. Toilet module needs to be cleaned and
maintenance regularly.
To Next Page
Loading...