Toilet Module Operation
Ensure the toilet system is functioning properly by locking the door. The
toilet has sensor inside and it turns on when toilet is in use. The
occupied light will make other passengers aware of the toilet status.
Toilet is unoccupied if the occupied light is off. If the toilet is occupied,
the occupied light will be on.
The dome light inside the toilet module has a dual status. The low light
level is on as long as the power to the module is on. The high light level
is on whenever a passenger enters the toilet module, closes, and locks
the door.
Sensor will automatically produce a flush that will go through the drain
valve into the wastewater holding tank.
Post Trip Procedures
After motor coach arrives at wastewater evacuation area, flip switch of
evacuation valve to drain holding tank.
WARNING
Do not spray water at the electrical junction box, fans, or other
electrical equipment. Doing so could damage equipment and
seriously injure personnel.
Remove all trash and restock supplies. Use a damp cloth to wipe the
surfaces. Sliding valve on holding tank should be cleaned regularly to
ensure smooth operation.
To Next Page
Loading...