GEAR SELECTOR
WARNING
Before starting a vehicle always be seated in the driver's seat,
select N on the shift control, and set the parking brakes.
WARNING
If engine cranks in any gear other than neutral, service your
vehicle immediately!
WARNING
Before working on a vehicle, parking the vehicle, or leaving the
cab with the engine running, place the transmission in neutral, set
the parking brakes, and block the wheels.
WARNING
For safety reasons, always engage the service brakes prior to
selecting gear positions from neutral.
WARNING
It is a requirement that the driver of a commercial vehicle specified
under paragraph A sections 1-6 of FMCSA regulation 392.10 need
only cross railroad grade crossings in a gear that permits the
vehicle to complete the crossing without a change of gears.
CAUTION
Do not release the parking brake or attempt to select a gear until
the air pressure is at the correct level.
CAUTION
Battery (+) and (-) must be disconnected prior to any type of
welding on any UltraShift™ equipped vehicle.
Gear selector lever has three positions operating panel.
•
R - Reverse. Selects reverse gear once vehicle is less than 2 Mph.
•
N - Neutral. Selects neutral.
•
D - Drive. Selects the default starting gear and automatically selects
gears between the starting gear and the top gear.
To Next Page
Loading...