EasyManua.ls Logo

CHTC HT45 - Ignition, Horn, and Brakes

Default Icon
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
Ignition Switch
WARNING
Do not turn the ignition key to the OFF position while the motor
coach is moving.
NOTE: In the event of failed start, wait 2 minutes before attempting to
re-start.
NOTE: If a re-start fails, check the fuel supply before any further
attempts.
The ignition switch is located on the right side of steering column. The
ignition switch has five positions. The following is an explanation of
those ignition switch positions:
LOCK - This position is used for inserting the key into the ignition
and for withdrawing the key from the ignition. This position is also
used for turning off the engine.
ACC - This position is used for powering only the radio and other
accessories.
ON - This position is used for the continuous period of engine
operation.
START - This position is used for engine startup only. Key will
automatically return to the ON position when released.
Horn
To use the horn, press either horn button located on the top of the
steering wheel center pad. The horn should sound while pressing down
on either button. The horn can be an electric or air horn, the electric/air
horn switch is located on the right switch panel.
PARKING BRAKE
The parking brake knob is located on the left console of the driver seat.
When the vehicle is stopped, pull out knob to set the parking brake.
When ready to start moving with engine running and primary air supply
at 90 psi, beeper and low air pressure light off. Place foot on brake
pedal and push in knob to release the brake.

Table of Contents