CIAT XtraConnect 2 - 5.4 Measured values menu

EN - 20
- If an automatic operation control or on/off fault occurs.
Example:
 Unit status table
-
Appears only if a message is displayed
Example:
 Circuit x status table:
- Appears only if a message is displayed
Example:
or for a time delay
5.4 Measured values menu
To access the MEASURED VALUES menu, use the + or – buttons to position the cursor on 3, then press OK (the list of submenus can then be accessed).
Position the cursor on CIRCUIT 2 or CIRCUIT 3 then press
OK . The values for the circuit selected appear.
Press
+ or – to scroll through the tables at a rate of two rows at a time.
Press the
ESC button to return to the main menu. Example:
For circuit 1
UNIT STATUS
ON/OFF
UNIT STATUS
FAN FAULT
CIRCUIT X STOP
LPx FAULT
CIRCUIT X STATE
ANTI-SHORT CYCLE Xx mnxxs
COMP.X UNAVAILABLE
MIN. STOP xmnxxs
CIRCUIT 2
CIRCUIT 3
COOLING INLET CTRL ↑
SETPOINT: -xx.x°↓
WATER INLET: -xx.x°↑
WATER OUTLET: -xx.x°↓
HP1 xx.xb T.COND1.xx.x°↑
DISCHARGE1 T.: -xx.x°
DESUPERHEAT 1: xx.x°↓
LIQUID1 T.: xx.x°↑
SUBCOOLING 1: -xx.x°
EXTERNAL TEMP.: xx.x°↓
LP1 xx.xb EVAP.T.1–x.x°↑
SUCTION 1 T.: xx.x°
SUPERHEAT 1 xx.x°↓
HOT WATER INLET -xx.x°↑
HOT WATER OUTLET -xx.x°
MAN WATER OUTLET xx.x°↓
U1:xxxV U2:xxxV U3:xxxV↑
TOTAL ABSORBED I: xxA
TOTAL ABSORBED P: xxkW↓
Evaporator in cooling mode.
Condenser in heating mode.
Identical for circuit
2, circuit 3 and
If measurement
of electrical quantities
(option) selected