19
Chapter 2 System Settings
Only one of these sets of values are acceptable – “0 or 1”, “Y or N” and “T or F”.
If a lookup field is specified, the input value will overwrite the lookup value.
If you input a value other than the above ones, a message will be displayed on the mobile
computer to indicate "Data type is wrong!"
No data input is allowed.
The prompt string will not be saved.
No data input is allowed.
The line needs to be reserved as an "extension" of the previous line so
can be displayed on the mobile computer screen.
Note: The number of extension lines depends on the maximum length of your data and
the screen size of the mobile computer.
Take the following for example –
If the screen of the mobile computer allows 20 characters per line for small font,
Now the prompt string
("Description :" in line 2) takes 13 characters, and the data length is 15
characters at most.
This makes the total length 28 characters at most, which is longer than one line.
As a result, the data type of line 3 needs to be set "extension" if you want to
data in full.
No data input is allowed.
The prompt string will not be saved. However, it will be highlighted constantly on the mobile
computer to catch your attention.
To Next Page
Loading...
Need help?
General
