Add new section “Battery Sensor” to Section 2.1: Battery.
Add description about “Doze Mode” to Section 2.7.7: Enterprise
Settings.
Add new section “Enable WLAN Blacklist” to Section 4.1: Use
Wireless Local Area Network (Wi-Fi).
Add description about “Intent Action” & “Intent Decode Data” to Section
5.2.1: General Settings.
Add new section “Data Formatting” to Chapter 5: ReaderConfig
Add “Important Safety Instructions and Warnings for
Li-ion/Polymer Battery” to “Important Notice”.
Add “Battery Mode Selection” to Section 2.1.5: Battery Precautions
Update Section 2.7.7: Enterprise Keypad Mode.
Update Section 3.3.1: Application Menu.
Add description about “Release Scan Mode”, “Aimer Mode”, & “Amier
Mode Timeout” to the table “2D Imager Settings” of Section 5.2.1:
General Settings.
Add “Key Event Delay Time” to the table “How to Output” of Section
5.2.1: General Settings.
Add high temperature warning to Section 2.1.5: Battery Precautions.
Update Section 3.3.1: Application Menu.
Update Chapter 5: ReaderConfig
Add 70° tilted reader model
Add “Battery Protection Mode” to Section 2.1.5: Battery
Precautions
Update Section 2.4.1: Status LED
Update Section 2.6.2: On-screen Keyboard
Add “Function Lock Mode” to Section 2.7.3: Function Key
Add Section 2.7.5: Enterprise Keypad Mode
Update Chapter 5 “Using Reader Configuration Utility”:
Update all figures.
Remove "Presentation Mode" & "Presentation Usage Time"
Change Import & Export file format to .json
Change "Tumble Test" in "Specification"
To Next Page
Loading...
Need help?
General
