4.1.2. MANUALLY ADD WI-FI NETWORK
If the network you would like to connect to does not broadcast its SSID, or if the network is
out of range, you may add it manually.
1) Go to App Drawer | Settings | WLAN
2) Slide down to the bottom of the page, and select “Add network”.
3) In the dialog box, enter the name of the network in the Network name field, and select
a security method in the Security field (None, WEP, WPA/WPA2 PSK, 802.1x EAP).
For WEP/WPA/WPA2 PSK connections: Enter the required password and tap Save.
For 802.1x EAP connections: Tap Advanced options and select the EAP method in the
drop-down box (PEAP, TLS, TTLS, PWD, SIM, AKA), and the Phase 2 authentication in
the drop-down box (None, MSCHAPV2, GTC). Select a CA certificate and User
certificate if required (certificates may be installed under
App Drawer | Settings | Security | Install from SD card
App Drawer | Settings | WLAN | More | Advanced | Install
certificates.)
Enter your username in the Identity box and the password in the Password box if
required.
The mobile computer supports the following certificate file extensions:
4) If necessary, select the Proxy server and IPv4 settings. By default, no proxy is set and
IP settings are set to DHCP.
DER-encoded X.509
certificates saved in
.crt or .cer files.
X.509 certificates saved in PKCS#12
key store files with a .p12 or .pfx
extension.
change the extension to
.crt or .cer.
Change the extension to
.p12 or .pfx.
To Next Page
Loading...
Need help?
General
