SYMBOLOGY SETTINGS (FOR SM2)
1D SYMBOLOGIES
Switch to enable Codabar decoding.
Set the length of the Codabar symbols to decode.
One Fixed length (Length 1)
Two Fixed lengths (Length 1>Length 2)
Max / Min Length (range: 0-55; Length 1<Length 2)
Any Length
When applied, the CLSI editing strips the start/stop
characters and inserts a space after the first, fifth, and
tenth characters of a 14-character Codabar barcode.
The 14-character barcode length does not include start/stop
characters.
Set whether to include start/stop characters in the
transmitted data.
NOTIS Editing is to strip the start/stop characters, i.e. to
disable "Transmit Start/Stop Characters".
Options are None, ABCD/ABCD, abcd/abcd.
“NOTIS Editing” must be enabled.
Select whether to verify the Modulo 43 check digit. If the
check digit is incorrect, the barcode will not be accepted.
Decide whether to include the check digit in the data to
transmit.
“Verify Check Digit” must be enabled.
Setting options are Normal and High.
To Next Page
Loading...
Need help?
General
