92
AFQm
Instruction Manual
11 Fit the fan cover, passing the fan cable through the wall bushing.
1.5 Nm
12 Connect the fans.
13 Tighten the fuse screws and the neutral connection bar.
2.2 Nm
14 Place the insulators.
15 Connect the display.
16 Tighten front cover screws.
1.5 Nm
17 Connect, power and start the AFQm.
18 Check the correct operation of the fans.
Figure 92: Maintenance screen.
To do this, go to the maintenance screen, via the configuration screen, by pressing the key
and entering the password to log into the maintenance screen (Maintenance password : 8888).
The screen in Figure 92 is displayed.
Checking the operation of the fans:
1.- Press the key , the fan starts to operate at a rotation speed of 50%; check that
it is working properly.
Press the key , to stop the fan.
2.- Press the key , the fan starts to operate at a rotation speed of 100%; check that it is
working properly.
Press the key , to stop the fan.
Note: The fans will stop if the key is not pressed after 1 minute.
To Next Page
Loading...