95
Instruction Manual
AFQm
5 Remove the insulators.
6 Remove the screws from the fuses and the neutral connection bar from the side of the board
3
7 Loosen the fuse screws on the side of the terminal block.
3
8 Remove de fuses.
9 Remove the 5 screws from the terminal block. Remove the bar from each of the phases.
2
10 Disconnect the upper floor fans.
11 Remove the 16 screws from the lower fan cover and disassemble. Run the fan cables from the upper
level through the wall bushing
2
12 Disconnect the lower floor fans.
13 Remove lower cover.
14 Replace the fans.
2 0.7 Nm
15 Place the lower cover.
16 Connect the fans on the lower level. Run the cables for the fans in the upper level through the
wall bushing.
17 Assemble the lower cover.
2 1.5 Nm
18 Connect the upper floor fans.
19 Tighten the bars to the terminal block.
2 2.2 Nm
20 Insert the Allen screws and nuts in the bar, but do not tighten.
21 Mount the fuses. Place the screws in the column. Tighten all the fuse screws.
2.2 Nm
22 Place the insulators.
23 Connect the display.
To Next Page
Loading...