Circutor Computer SMART III 6 User Manual

Press to validate the data; the symbol disappears from the display.
Maximum value: 999 mA.
Minimum value: 1 mA.
If the value entered is lower than the minimum value or higher than the maximum value, the backlight
of the display flashes and the value entered is replaced with the minimum or maximum value, or with
the last value validated.
Press the key to access the next programming step.
If no keys are pressed for 5 minutes, the device switches to the simulation screen, “5.30.- SIMULATION
SCREEN”.
5.29.- NO. OF OPERATIONS ALARM
In this point the number of operations of any of the stages above which the alarm E17 will be
triggered can be configured.
Note: The alarm must be enabled (“5.21.- ENABLING ALARMS”).
Press the key to enter edit mode. It is identified by the symbol and the flashing of the
digits to be modified.
The key increases the digit value.
The key reduces the digit value.
The key skips to the previous digit and the key skips to the next digit.
Press to validate the data; the symbol disappears from the display.
Maximum value: 99999.
Minimum value: 10.
If the value entered is lower than the minimum value or higher than the maximum value, the backlight
of the display flashes and the value entered is replaced with the minimum or maximum value, or with
the last value validated.
104
Computer SMART III
Instruction Manual

Circutor Computer SMART III 6 Specifications

General

Brand	Circutor
Model	Computer SMART III 6
Category	Controller
Language	English