Press to validate the data; the symbol disappears from the display.
Press the key to access the next programming step.
If no keys are pressed for 5 minutes, the device switches to the simulation screen, “5.30.- SIMULATION
SCREEN”.
5.8.- PROGRAM
The device is made up of stages with different powers. The base power (value 1) will be that of the
stage with the lowest power. The powers of all the other stages will depend on the power of the first
stage.
Example:
Program 1.1.1.1, all the stages have the same power as the first one.
Program 1.2.4.4, the second stage has twice the power and the next ones have four times the power
of the first one. (See “4.1.4. REGULATION PROGRAM”)
When configuring the program, remember that the subsequent stage cannot be lower than the prior
stage, and that the first stage is always 1.
Press the key to enter edit mode. It is identified by the symbol and the flashing of the
digits to be modified.
The key increases the digit value.
The key reduces the digit value.
The key skips to the previous digit and the key skips to the next digit.
Press to validate the data; the symbol disappears from the display.
Minimum value: 1.1.1.1
Maximum value: 1.9.9.9
Press the key to access the next programming step.
If no keys are pressed for 5 minutes, the device switches to the simulation screen, “5.30.- SIMULATION
SCREEN”.
81
Instruction Manual
Computer SMART III
To Next Page
Loading...
