3.- DEVICE INSTALLATION
3.1.- PRIOR RECOMMENDATIONS
In order to use the device safely, it is critical that individuals who handle it follow the
safety measures set out in the standards of the country where it is being used, use the
necessary personal protective equipment, and pay attention to the various warnings
indicated in this instruction manual.
The Computer SMART III device must be installed by authorised and qualified staff.
The power supply plug must be disconnected and measuring systems switched off before handling, al-
tering the connections or replacing the device. It is dangerous to handle the device while it is powered.
Also, it is critical to keep the cables in perfect condition in order to avoid accidents, personal injury and
damage to installations.
The manufacturer of the device is not responsible for any damage resulting from failure by the user
or installer to heed the warnings and/or recommendations set out in this manual, nor for damage
resulting from the use of non-original products or accessories or those made by other manufacturers.
If an anomaly or malfunction is detected in the device, do not use it to take any measurements.
Inspect the work area before taking any measurements. Do not take measurements in dangerous ar-
eas or where there is a risk of explosion.
Disconnect the device from the power supply (device and measuring system power
supply) before maintaining, repairing or handling the device's connections.
Please contact the after-sales service if you suspect that there is an operational fault
in the device.
3.2.- RECOMMENDATIONS FOR USING THE COMPUTER SMART III REGULATOR IN MEDIUM-VOLT-
AGE AUTOMATIC CAPACITOR BANKS
Computer SMART III regulators can also be used for controlling medium-voltage automatic capacitor
banks, always under the full responsibility of the personnel responsible for starting it up, and taking
into account the various recommendations mentioned below, which should be strictly observed in
every case in order to avoid the possible appearance of problems in the various elements that make
up the capacitor bank.
The voltage and current measurement signals must be supplied to the regulator from
voltage and current transformers that are suitable for the tolerable ranges of the volt-
age and current measurement inputs of the regulator.
9
Instruction Manual
Computer SMART III
To Next Page
Loading...
Need help?
General
