Circutor Computer SMART III 6 - Page 56

AutoTest Parameters
AutoTest home screen.
To start the AutoTest:
Press the key, OFF flashes.
Press the key to switch from OFF to START
Press the key to start the AutoTest
Once the AutoTest has started, the results of the
capacitors that are connected and disconnected
are shown:
Leakage current (mA)
Capacitive Reactive Power
(kvarC or MvarC)
Capacitive Power % of each capacitor relative
to the total estimated value.
The icon flashes during the AutoTest.
A long keystroke (> 3 s) of the key cancels the AutoTest.
At the end of the AutoTest, the device automatically returns to the Individual Test screen.
Step Test Parameters
Leakage current (mA)
Capacitive Reactive Power
(kvarC or MvarC)
Capacitive Power % of each capacitor relative
to the total estimated value.
Switches between the various
capacitors.
A long keystroke (> 3 s) of the key connects the capacitor that is being displayed, taking into
account the programmed connection and reclosing times.
A long keystroke (> 3 s) of the key disconnects the capacitor that is being displayed, taking into
account the programmed connection and reclosing times.
56
Computer SMART III
Instruction Manual