NIAGARA SCX WEB INTERFACE
You can then return to the All Encoders page. The new encoder you created is added to the encoder
list. You can then edit that encoder by clicking the Edit link next to the encoder name. Read
previous section entitled the Edit Encoder for information on how to edit the encoder you just
created.
Encoder Preset (A, B, & C)
The Cisco Digital Media Encoder 2000 provides one-button streaming via the EZStream buttons
located on the front panel of the system. By default, these buttons are not assigned to an encoder.
The Niagara SCX Web Interface is used to configure each button to a specific encoder. The controls
to configure these buttons are located in the Encoder Preset A, Encoder Preset B, and Encoder
Preset C pages.
When you access the Encoder Preset A page, you are presented with the configuration option for the
EZStream A button. On this page is a graphic representation of the front panel of the Cisco Digital
Media Encoder 2000. The A button is highlighted on this graphic, which sets forth you are actively
assigning an encoder to this corresponding EZStream button.
Cisco Digital Media Encoder 2000 User Guide 116
To Next Page
Loading...
Need help?
General
