Cisco 2950G 24 - Catalyst Switch - Page 625

Index
IN-9
Catalyst 2950 Desktop Switch Software Configuration Guide
78-14982-01
using FTP B-26
using RCP B-30
using TFTP B-23
DSCP 1-6, 26-2
DSCP-to-CoS map for QoS 26-26
DTP 1-5, 14-15
duplex mode
configuring
10-7
CPE Ethernet link 10-7
duplex mode, configuring 9-11
dynamic access mode 3-10
dynamic access ports
characteristics
14-3
configuring 14-29
defined 9-2
dynamic addresses
See addresses
dynamic desirable trunking mode
14-16
dynamic port VLAN membership
described
14-25
reconfirming 14-30
troubleshooting 14-31
types of connections 14-29
VMPS database configuration file 14-26
Dynamic Trunking Protocol
See DTP
E
editing features
enabling and disabling
2-7
keystrokes used 2-8
wrapped lines 2-9
egress port scheduling 26-8
enable password 7-4
enable secret password 7-4
encapsulation 26-8
encrypted software image 7-33
encryption for passwords 7-4
error checking, CMS 3-32
error messages
during command entry
2-5
setting the display destination device 23-4
severity levels 23-8
system message format 23-2
EtherChannel
automatic creation of
27-3
configuration guidelines 27-8
default configuration 27-7
destination MAC address forwarding 27-5
displaying status 27-11
forwarding methods 27-5, 27-10
interaction
with STP
27-8
with VLANs 27-8
Layer 2 interfaces, configuring 27-8
load balancing 27-5, 27-10
number of interfaces per 27-2
overview 27-1
PAgP
aggregate-port learners
27-5
compatibility with Catalyst 1900 27-11
displaying status 27-11
interaction with other features 27-5
learn method and priority configuration 27-11
modes 27-4
overview 27-3
silent mode 27-4
support for 1-3
port-channel interfaces
described
27-2
numbering of 27-2
port groups 9-3
source MAC address forwarding 27-5
Ethernet VLANs
adding
14-8
defaults and ranges 14-8
modifying 14-8