Index
IN-25
Catalyst 2950 Desktop Switch Software Configuration Guide
78-14982-01
source ports 21-4
transmitted traffic 21-4
VLAN-based 21-6
spanning tree and native VLANs 14-17
Spanning Tree Protocol
See STP
speed, configuring on interfaces
9-11
speed, setting 10-7
SSH
configuring
7-33
crypto software image 7-33
described 7-33
displaying settings 7-33
Stack Membership Discovery Protocol 13-6
Standby Command Configuration window 6-23
standby command switch
configuring
6-22
considerations 6-13
defined 6-2
priority 6-12
requirements 6-3
virtual IP address 6-13
See also cluster standby group and HSRP
standby group, cluster
See cluster standby group and HSRP
startup configuration
clearing
B-19
static access mode 3-10
static access ports
assigning to VLAN
14-11
defined 9-2, 14-3
static addresses
See addresses
static VLAN membership
14-2
statistics
802.1X
8-14
CDP 20-5
CPE Ethernet link 28-4
interface 9-17
LRE link 28-4
port 28-2
QoS ingress and egress 26-28
RMON group Ethernet 22-5
RMON group history 22-5
SNMP input and output 24-15
VTP 15-16
status bar
change notification
3-32
error notification 3-32
sticky learning 18-5
storm control
described
18-1
displaying 18-12
STP
accelerating root port selection
13-4
BackboneFast
described
13-10
enabling 13-19
BPDU filtering
described
13-3
enabling 13-16
BPDU guard
described
13-3
enabling 13-15
BPDU message exchange 11-2
configuration guidelines 11-10
configuring
forward-delay time
11-19
hello time 11-19
in cascaded stack 11-20
maximum aging time 11-20
path cost 11-16
port priority 11-15, 12-17
root switch 11-12
secondary root switch 11-14
switch priority 11-18
cross-stack UplinkFast
described
13-5
To Next Page
Loading...
