Cisco 6901 Administration Guide

5-15
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24582-01
Chapter 5 Configuring Features, Templates, Services, and Users
Setting up UCR 2008
Configuring UCR 2008 in Phone
Use this procedure to set the following UCR 2008 parameters:
• SSH Access
• Web Access
Step 1 Choose Device > Phone.
Step 2 Set the SSH Access parameter to Disabled.
Step 3 Set the Web Access parameter to Disabled.
Step 4 Click Save.
Configuring UCR 2008 in Common Phone Profile
Use this procedure to set the following UCR 2008 parameters:
Table 5-3 UCR 2008 parameter location
Parameter Administration Path Procedure
FIPS Mode Device > Device Settings > Common
Phone Profile
Configuring UCR 2008 in
Common Phone Profile,
page 5-15
System > Enterprise Phone Configuration Configuring UCR 2008 in
Enterprise Phone Configuration,
page 5-16
SSH Access Device > Phone Configuring UCR 2008 in Phone,
page 5-15
Device > Device Settings > Common
Phone Profile
Configuring UCR 2008 in
Common Phone Profile,
page 5-15
Web Access Device > Phone Configuring UCR 2008 in Phone,
page 5-15
80-bit SRTCP Device > Device Settings > Common
Phone Profile
Configuring UCR 2008 in
Common Phone Profile,
page 5-15
System > Enterprise Phone Configuration Configuring UCR 2008 in
Enterprise Phone Configuration,
page 5-16
IP Addressing Mode Device > Device Settings > Common
Device Configuration
Configuring UCR 2008 in
Common Device Configuration,
page 5-16
IP Addressing Mode
Preference for
Signaling
Device > Device Settings > Common
Device Configuration
Configuring UCR 2008 in
Common Device Configuration,
page 5-16

Cisco 6901 Specifications

General

Model	6901
Type	IP Phone
Power over Ethernet (PoE)	Yes
Protocols	SCCP
Codecs	G.711, G.729