Cisco 6901 Administration Guide

5-9
Cisco Unified IP Phone 6901 and 6911 Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
OL-24582-01
Chapter 5 Configuring Features, Templates, Services, and Users
Adding Users to Cisco Unified Communications Manager
Adding Users to Cisco Unified Communications Manager
Adding users to Cisco Unified Communications Manager allows you to display and maintain
information about users and allows each user to perform these tasks:
• Create a personal directory.
• Set up speed dial and call forwarding numbers.
You can add users to Cisco Unified Communications Manager using one of these following methods:
• To add users individually, choose User Management > End User from Cisco Unified
Communications Manager.
For more information, go to the End User Configuration chapter in the Cisco Unified
Communications Manager Administration Guide.
• To add users in batches, use the Bulk Administration Tool. This method also enables you to set an
identical default password for all users.
For more information, go to the “Bulk Administration” chapter in Cisco Unified Communications
Manager Administration Guide.
• To add users from your corporate LDAP directory, choose System > LDAP > LDAP System from
Cisco Unified Communications Manager.
Note After Enable Synchronization from the LDAP Server is enabled, you cannot add additional
users from Cisco Unified Communications Manager Administration.
For more information on LDAP, go to the “Understanding the Directory” chapter in the Cisco
Unified Communications Manager System Guide.
• To add a user and phone at the same time, choose User Management > User/Phone Add from Cisco
Unified Communications Manager.
Managing the User Options Web Pages
From the User Options web page, users can customize and control several phone features and settings.
For detailed information about the User Options web pages, refer to Cisco Unified IP Phone 6901 and
6911 User Guide for Cisco Unified Communications Manager.
Voice messaging
system
Enables callers to leave messages if calls are
unanswered.
Messages are accessed using the Message button
on the Cisco Unified IP Phone 6911.
Messages are accessed using the access code on the
Cisco Unified IP Phone 6901.
For more information refer to:
• Cisco Unified Communications Manager
Administration Guide, “Cisco Voice-Mail
Port Configuration” chapter.
• Cisco Unified Communications Manager
System Guide, “Voice Mail Connectivity
to Cisco Unified Communications
Manager” chapter.
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description Configuration Reference

Cisco 6901 Specifications

General

Model	6901
Type	IP Phone
Power over Ethernet (PoE)	Yes
Protocols	SCCP
Codecs	G.711, G.729