Cisco 7965G Administration Guide

5-8
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12650-01
Chapter 5 Configuring Features, Templates, Services, and Users
Telephony Features Available for the Phone
Direct transfer
(SCCP phones
only)
Allows users to connect two calls to each
other (without remaining on the line).
For more information, refer to
Cisco Unified Communications
Manager System Guide, “Cisco
Unified IP Phones” chapter.
Do Not Disturb
(DND)
When DND is turned on, no audible rings
occur during the ringing-in state of a call.
You can configure the phone to have a softkey
template with a DND softkey or a
phone-button template with DND as one of
the selected features.
The following DND-related parameters are
configurable in Cisco
Unified
Communications Manager administration:
• Do Not Disturb—This checkbox allows
you to enable DND on a per-phone basis.
Use Cisco Unified Communications
Manager Administration > Device >
Phone > Phone Configuration.
• DND Incoming Call Alert—Choose the
type of alert to play on a phone for
incoming calls when DND is active. This
parameter is located on both the Common
Phone Profile page and the Phone
configuration page (Phone page value
takes precedence).
• Include DND In BLF Status—Enables
DND status to override busy/idle state.
• Include DND In BLF Status—Enables
DND status to override busy/idle state.
Note The user can use Cisco Unified
Communications Manager User
Options pages to enable/disable DND,
and to change DND Incoming Call
Alert and DND Timeout settings.
Cisco Unified Communications
Manager Features and Services
Guide, “Do Not Disturb” chapter.
Extension Mobility
Service
(SCCP phones
only)
Allows a user temporarily to apply a phone
number and user profile settings to a shared
Cisco Unified IP Phone by logging into the
Extension Mobility service on that phone.
Extension Mobility can be useful if users
work from a variety of locations within your
company or if they share a workspace with
coworkers.
For more information, refer to
the Cisco
Unified
Communications
Manager Features and Services
Guide, “Cisco Unified
Communications Manager
Extension Mobility” chapter.
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description Configuration Reference

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC