Cisco 7965G Administration Guide

5-10
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12650-01
Chapter 5 Configuring Features, Templates, Services, and Users
Telephony Features Available for the Phone
Hunt Group Provides load sharing for calls to a main
directory number. A hunt group contains a
series of directory numbers that can answer
the incoming calls. When the first directory
number in the hunt group is busy, the system
hunts in a predetermined sequence for the
next available directory number in the group
and directs the call to that phone.
For more information, refer to:
• Cisco Communications
Manager Administration
Guide, “Hunt Group
Configuration” chapter.
• Cisco Communications
Manager System Guide,
“Understanding Route
Plans” chapter.
Immediate Divert Allows a user to transfer a ringing, connected,
or held call directly to a voice-messaging
system. When a call is diverted, the line
becomes available to make or receive new
calls.
For more information, refer to
the Unified
Communications
Manager Features and Services
Guide, “Immediate Diver”
chapter.
Intercom Allows users to place and receive intercom
calls using programmable phone buttons. You
can configure intercom line buttons to:
• Directly dial a specific intercom
extension.
• Initiate an intercom call and then prompt
the user to enter a valid intercom number.
Note Cisco Extension Mobility does not
support intercom lines.
Cisco Unified Communications
Manager Feature and Services
Guide, “Intercom chapter”
Join
(SCCP phones
only)
Allows user to join two or more calls that are
on one line to crate a conference call and
remain on the call.
For more information:
• See the “Configuring
Softkey Templates” section
on page 5-18.
• Refer to Cisco
Unified
Communications
Manager System Guide,
“Cisco Unified IP Phones”
chapter.
Log out of hunt
groups
Allows users to log out of a hunt group and
temporarily block calls from ringing their
phone when they are not available to take
calls. Logging out of hunt groups does not
prevent non-hunt group calls from ringing
their phone.
For more information
• See the “Configuring
Softkey Templates” section
on p.
• Cisco Communications
Manager System Guide,
“Understanding Route
Plans” chapter.
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description Configuration Reference

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC