Cisco 7965G Administration Guide

4-9
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
OL-12650-01
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Network Configuration Menu
DHCP Enabled Indicates whether DHCP is being used by
the phone.
1. Unlock network configuration
options.
2. Scroll to the DHCP Enabled
option and press the No
softkey to disable DHCP, or
press the Yes softkey to enable
DHCP.
3. Press the Save softkey.
DHCP Address
Released
Releases the IP address assigned by DHCP. 1. Unlock network configuration
options.
2. Scroll to the DHCP Address
Released option and press the
Yes softkey to release the IP
address assigned by DHCP, or
press the No softkey if you do
not want to release this IP
address.
3. Press the Save softkey.
Alternate TFTP Indicates whether the phone is using an
alternative TFTP server.
1. Unlock network configuration
options.
2. Scroll to the Alternate TFTP
option and press the Yes
softkey if the phone should use
an alternative TFTP server.
Press the No softkey
otherwise.
3. Press the Save softkey.
Table 4-2 Network Configuration Menu Options (continued)
Option Description To Change

Cisco 7965G Specifications

General

Protocol Support	SIP, SCCP
Weight	3.5 lbs (1.6 kg)
Ethernet	10/100 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE)
Expansion Module Support	Supports up to two Cisco Unified IP Phone Expansion Modules
Speakerphone	Full-duplex speakerphone
Lines	6 lines
Codecs	G.711, G.729a, iLBC