Table 2: Maximum Power Available when using DC Power Modules
N+1 Redundancy Mode in Watts (with Single
Supply Loss)
Combined Mode in Watts (No
redundancy)
Total Power
Supply
—30001
300060002
Table 3: Maximum Power Available when using DC Power Module
Combined Mode in Watts (No redundancy)Total Power
Supply
30001
The power supply units (PSUs) deliver the above stated output power (e.g., 3,000W) to the switch However,
the wall power or input power to the switch will be high due to conversion efficiencies.
Note
Supported Optics
To determine which transceivers and cables are supported by this switch, refer to the Transceiver Module
Group (TMG) Compatibility Matrix Tool:
https://tmgmatrix.cisco.com/home
Note
Hardware Installation Guide for Cisco 8500 Switches
10
Cisco 8500 Switch Overview
Supported Optics
To Next Page
Loading...
