CHAPTER 3
Unpack and Install the Chassis
The images in this chapter are only for representation purposes, unless specified otherwise. The chassis' actual
appearance and size may vary.
Note
• Unpack the Chassis, on page 23
• Install Bottom-Support Rails, on page 24
• Transfer Chassis to a Mechanical Lifting Device, on page 27
• Mount Chassis Into the Rack, on page 28
Unpack the Chassis
Be sure to save the packaging in case you need to return any of the components products.
Tip
Ensure that there is sufficient room around the chassis pallet for unpacking. For information about the chassis
dimensions and clearance requirements see, Clearance Requirements.
Carefully move the pallet containing the chassis to the staging area where you plan on unpacking it.
Hardware Installation Guide for Cisco 8500 Switches
23
To Next Page
Loading...
